Most Chicago-area trouble for trucks isn’t traffic — it’s a low railroad viaduct or a road trucks aren’t allowed on. Plan the last few miles before you leave the expressway.
Roads trucks can’t use
- Lake Shore Drive (DuSable Lake Shore Drive) is closed to commercial vehicles along its whole length.
- Park boulevards — Chicago’s boulevard system (for example the boulevards linking the big parks on the South and West Sides) also bans commercial vehicles. City truck rules are in the Chicago Municipal Code (Chapter 9-72).
- Many residential streets and some suburban roads post weight limits. Follow the signs even if your GPS says otherwise.
Low clearances
- Chicago has hundreds of railroad viaducts, many under 13'6". Check the CDOT viaduct clearance list before routing on surface streets — entries marked “NP” are over 14'6".
- Lower Wacker Drive and other lower-level downtown streets have clearances around 12 feet and lower in spots. Don’t take a trailer down there.
- Use a truck GPS or app set to your real height (most vans are 13'6"), and believe the posted sign over the app.
State truck routes
Illinois uses designated truck routes. Interstates and tollways are Class I; Class II routes are designated highways with 11-foot lanes. Designated routes allow the federal limits — 80,000 lb gross and 102-inch width — and 53-foot trailers. Check the IDOT Designated Truck Route map before leaving the network for a shipper or receiver.
Getting around the grid
Chicago addresses count out from State and Madison streets, roughly 800 numbers to a mile — so 4800 S is about six miles south of downtown. Handy when a receiver gives you only an address.
Tolls
The Illinois Tollway (I-90, I-88, I-294, I-355 and I-94 north of the city), the Chicago Skyway and the Indiana Toll Road all charge trucks by axle. Pay missed tolls promptly on the Illinois Tollway site or the Indiana Toll Road site to avoid fines.
Last checked November 15, 2026. Rules change — follow posted signs and official sources. In an emergency, call 911.